RUT956
ROUTER CELULAR INDUSTRIAL
El RUT956 es un router industrial que combina opciones de conectividad móvil, Wi-Fi y por cable con funciones de conmutación automática por error de WAN y GNSS. Las interfaces de comunicación serie permiten integrar dispositivos más variados en el ecosistema de soluciones, mientras que las E/S y el software avanzado RutOS facilitan el control de equipos, la automatización y las notificaciones de eventos.
-
MOBILE
4G (LTE) – Cat 4 up to 150 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps
2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection
Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, Bytes sent/received, connected band, IMSI, ICCID
SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP
Supports sending and reading Unstructured Supplementary Service Data messages
Operator black/white list
Possibility to use different PDNs for multiple network access and services
Band lock, Used band status display
Auto APN
Direct connection (bridge) between mobile ISP and device on LAN
Router assigns its mobile WAN IP address to another device on LAN
WIRELESS
IEEE 802.11b/g/n, Access Point (AP), Station (STA)
WPA2-Enterprise - PEAP, WPA2-PSK, WEP, WPA-EAP, WPA-PSK; AES-CCMP, TKIP, Auto Cipher modes, client separation
SSID stealth mode and access control based on MAC address
Up to 100 simultaneous connections
Captive portal (Hotspot), internal/external Radius server, built in customizable landing page
ETHERNET
1 x WAN port 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX
3 x LAN ports, 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX
NETWORK
Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, NHRP)
TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SMNP, MQTT, Wake On Lan (WOL)
H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets
Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection
Port forward, traffic rules, custom rules
Static and dynamic IP allocation, DHCP Relay, Relayd
- QoS / Smart Queue Management (SQM)
Traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e
Supported >25 service providers, others can be configured manually
WiFi WAN, Mobile, VRRP, Wired options, each of which can be used as an automatic Failover
Balance Internet traffic over multiple WAN connections
Captive portal (Hotspot), internal/external Radius server, SMS authorization, internal/external landing page, walled garden, user scripts, URL parameters, user groups, individual user or group limitations, user management, 9 default customizable themes
Possibility to mount remote file system via SSH protocol
SECURITY
Pre-shared key, digital certificates, X.509 certificates, TACACS+, Radius, IP & Login attempts block
Pre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T
DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks)
Port and tag based VLAN separation
Custom data limits for both SIM cards
Blacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only
Flexible access control of TCP, UDP, ICMP packets, MAC address filter
VPN
Multiple clients and a server can run simultaneously, 27 encryption methods
DES-CBC 64, RC2-CBC 128, DES-EDE-CBC 128, DES-EDE3-CBC 192, DESX-CBC 192,
BF-CBC 128, RC2-40-CBC 40, CAST5-CBC 128, RC2-64-CBC 64, AES-128-CBC 128, AES-128-CFB 128, AES-128-CFB1 128, AES-128-CFB8 128, AES-128-OFB 128, AES-128-GCM 128, AES-192-CFB 192, AES-192-CFB1 192, AES-192-CFB8 192, AES-192-OFB 192, AES-192-CBC 192, AES-192-GCM 192, AES-256-GCM 256, AES-256-CFB 256, AES-256-CFB1 256, AES-256-CFB8 256, AES-256-OFB 256, AES-256-CBC 256
IKEv1, IKEv2, with 14 encryption methods for IPsec (3DES, DES, AES128, AES192, AES256, AES128GCM8, AES192GCM8, AES256GCM8, AES128GCM12, AES192GCM12, AES256GCM12, AES128GCM16, AES192GCM16, AES256GCM16)
GRE tunnel, GRE tunnel over IPsec support
Client/Server instances can run simultaneously, L2TPv3, L2TP over IPsec support
Proxy designed to add TLS encryption functionality to existing clients and servers without any changes in the program’s code
Method of building scalable IPsec VPNs
SSTP client instance support
ZeroTier VPN client support
WireGuard VPN client and server support
Tinc offers encryption, authentication and compression in it's tunnels. Client and server support.
MODBUS TCP SLAVE
Respond to one ID in range [1;255] or any
Allow access through WAN
MODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Slave functionality
MODBUS TCP MASTER
01, 02, 03, 04, 05, 06, 15, 16
8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC)
MODBUS RTU MASTER (RS232)
From 300 to 115200
01, 02, 03, 04, 05, 06, 15, 16
8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII
From 5 to 8
1 or 2
None, Even, Odd
None, RTS/CTS, Xon/Xoff
Full duplex
MODBUS RTU MASTER (RS485)
From 300 to 300000
01, 02, 03, 04, 05, 06, 15, 16
8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII
8
1
None, Even, Odd
None, Xon/Xoff
Half duplex
MODBUS DATA TO SERVER
HTTP(S), MQTT, Azure MQTT
MQTT GATEWAY
Allows sending commands and receiving data from MODBUS Master through MQTT broker
DNP3
TCP Master, DNP3 Outstation, RTU Master
MONITORING & MANAGEMENT
HTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, event log, system log, kernel log
Firmware update from server, automatic notification
SSH (v1, v2)
SMS status, SMS configuration, send/read SMS via HTTP POST/GET
Reboot, Status, Mobile data on/off, Output on/off, answer/hang-up with a timer, WiFi on/off
OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem
MQTT Broker, MQTT publisher
SNMP (v1, v2, v3), SNMP Trap
Management API over HTTP/HTTPS
MODBUS TCP status/control
Teltonika Remote Management System (RMS)
IOT PLATFORMS
Allows monitoring of: Device data, Mobile data, Network info, Availability
Allows monitoring of: WAN Type, WAN IP, Mobile Operator Name, Mobile Signal Strength, Mobile Network Type
Allows monitoring of: Device Model, Revision and Serial Number, WAN Type and IP, Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength
Can send device IP, Number of bytes send/received, Temperature, PIN count to Azure IoT Hub server, Mobile connection state, Network link state, IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, SIM State, PIN state, GSM signal, WCDMA RSCP, WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ, CELL ID, Operator, Operator number, Connection type
SYSTEM CHARACTERISTICS
Mediatek MIPS 24Kc 580 MHz
128 MB, DDR2
16 MB, SPI Flash
FIRMWARE / CONFIGURATION
Update FW from file, check FW on server, configuration profiles, configuration backup
Update FW
Update FW/configuration for multiple devices at once
Update FW without losing current configuration
FIRMWARE CUSTOMIZATION
RutOS (OpenWrt based Linux OS)
Busybox shell, Lua, C, C++
SDK package with build environment provided
LOCATION TRACKING
GPS, GLONASS, BeiDou, Galileo and QZSS
GNSS coordinates via WebUI, SMS, TAVL, RMS
NMEA 0183
NTRIP protocol (Networked Transport of RTCM via Internet Protocol)
Supported server software TAVL, RMS
Configurable multiple geofence zones
SERIAL
DB9 connector, full RS232 (with RTS, CTS)
RS485 Full Duplex (4 wires) and Half Duplex (2 wires). 300-115200 baud rate
Console, Serial over IP, Modem, MODBUS gateway, NTRIP Client
USB
USB 2.0
Samba share, USB-to-serial
Possibility to connect external HDD, flash drive, additional modem, printer
FAT, FAT32, NTFS
INPUT / OUTPUT
1 x digital dry input (0 - 3 V), 1 x digital galvanically isolated input (0 - 30 V), 1 x analog input (0 - 24 V), 1 x Digital non-isolated input (on 4-pin power connector, 0 - 5 V detected as logic low, 8 - 30 V detected as logic high)
1 x digital open collector output (30 V, 250 mA), 1 x SPST relay output (40 V, 4 A), 1 x Digital open collector output (30 V, 300 mA, on 4-pin power connector)
Email, RMS, SMS
Allows to set certain I/O conditions to initiate event
POWER
4-pin industrial DC power socket
9 – 30 VDC, reverse polarity protection; surge protection >31 VDC 10us max
Passive PoE over spare pairs. Possibility to power up through LAN port, not compatible with IEEE802.3af, 802.3at and 802.3bt standards, Mode B, LAN1 Port, 9 - 50 VDC
< 2 W idle, < 7 W Max
PHYSICAL INTERFACES
4 x RJ45 ports, 10/100 Mbps
2 x Inputs and 2 x Outputs on 10-pin industrial socket, 1 x Digital input and 1 x Digital output on 4-pin power connector (available from HW revision 1600)
1 x bi-color connection status LED, 5 x connection strength LEDs, 4 x LAN status LEDs, 1 x Power LED
2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders, eSIM (Optional)
1 x 4-pin power connector
1x 10 pin industrial socket for inputs/outputs
2 x SMA for LTE, 2 x RP-SMA for WiFi, 1 x SMA for GNSS
1 x USB A port for external devices
1 x DB9 socket
1 x 6-pin industrial socket
Reboot/User default reset/Factory reset button
PHYSICAL SPECIFICATION
Aluminium housing, plastic panels
110 x 50 x 100 mm
287 g
DIN rail (can be mounted on two sides), flat surface placement
OPERATING ENVIRONMENT
-40 °C to 75 °C
10% to 90% non-condensing
- Ingress Protection Rating
IP30
REGULATORY & TYPE APPROVALS
CE/RED, UKCA, CB
EMI IMMUNITY
EN 301 489-1 V2.2.3, EN 301 489-17 V3.2.4, Draft EN 301 489-19 V2.2.0, Final draft EN 301 489-52 V1.2.0, EN 55032:2015+A1:2020, EN 55035:2017+A11:2020, EN 61000-3-3:2013+A1:2019, EN IEC 61000-3-2:2019
EN 61000-4-2:2009
EN 61000-4-3:2020
EN 61000-4-4:2012
- Surge immunity (AC Power Line)
EN 61000-4-5:2014+A1:2017
EN 61000-4-6:2009
EN IEC 61000-4-11:2020
PERFORMANCE SPECIFICATIONS
EN 300 328 V2.2.2, EN 301 908-1 V13.1.1, EN 301 908-2 V13.1.1, EN 301 908-13 V13.1.1, EN 303 413 V1.1.1
SAFETY
EN IEC 62311:2020
AS/NZS 60950.1:2015
IEC 62368-1:2018,
EN IEC 62368-1:2020+A11:2020